A CFD STUDY OF CAVITATION IN REAL SIZE DIESEL INJECTORS

Resumen

In Diesel engines, the internal flow characteristics in the fuel injection nozzles, such as the turbulence level and distribution, the cavitation pattern and the velocity profile affect significantly the air-fuel mixture in the spray and subsequently the combustion process. Since the possibility to observe experimentally and measure the flow inside real size Diesel injectors is very limited, Computational Fluid Dynamics (CFD) calculations are generally used to obtain the relevant information. The work presented within this thesis is focused on the study of cavitation in real size automotive injectors by using a commercial CFD code. It is divided in three major phases, each corresponding to a different complementary objective. The first objective of the current work is to assess the ability of the cavitation model included in the CFD code to predict cavitating flow conditions. For this, the model is validated for an injector-like study case defined in the literature, and for which experimental data is available in different operating conditions, before and after the start of cavitation. Preliminary studies are performed to analyze the effects on the solution obtained of various numerical parameters of the cavitation model itself and of the solver, and to determine the adequate setup of the model. It may be concluded that overall the cavitation model is able to predict the onset and development of cavitation accurately. Indeed, there is satisfactory agreement between the experimental data of injection rate and choked flow conditions and the corresponding numerical solution.This study serves as the basis for the physical and numerical understanding of the problem. Next, using the model configuration obtained from the previous study, unsteady flow calculations are performed for real-size single and multi-hole sac type Diesel injectors, each one with two types of nozzles, tapered and cylindrical. The objective is to validate the model with real automotive cases and to ununderstand in what way some physical factors, such as geometry, operating conditions and needle position affect the inception of cavitation and its development in the nozzle holes. These calculations are made at full needle lift and for various values of injection pressure and back-pressure. The results obtained for injection rate, momentum flux and effective injection velocity at the exit of the nozzles are compared with available CMT-Motores Térmicos in-house experimental data. Also, the cavitation pattern inside the nozzle and its effect on the internal nozzle flow is analyzed. The model predicts with reasonable accuracy the effects of geometry and operating conditions.