Estimación analítica de las variables de funcionamiento óptimas de un distribuidor centrífugo de fertilizante, usando el método del gradiente sobre múltiples semillas

  1. Jaime Gómez-Gil
  2. Alfonso de-Lózar-Escudero
  3. L. Manuel Navas-Gracia
  4. Gonzalo Ruiz-Ruiz
Revista:
Agrociencia

ISSN: 1405-3195,  2521-9766

Any de publicació: 2009

Volum: 43

Número: 5

Pàgines: 497-509

Tipus: Article

DIALNET GOOGLE SCHOLAR lock_openAccés obert editor

Altres publicacions en: Agrociencia

Resum

The optimal adjustment of operation variables of a fertilizer machine with centrifugal distributors for obtaining a good variation coefficient is essential for uniform fertilizer distribution on farmland. This article presents a computerized application in order to predict analytically the distribution profile and the variation coefficient of agricultural fertilizer machines with centrifugal disk distributors. Furthermore, this application calculates the values of fertilizer adjustment variables, which offer a better variation coefficient, using the gradient method on multiple seeds. With these optimal parameters of fertilizer adjustment variables, variation coefficient results are obtained, similar to those of the most prestigious trademarks of fertilizing equipment. A particular case is shown with small disks and moderate turn speed with which a work width of 22 m is achieved, similar to the ones obtained with the fertilizing equipment of these distributors. The use of this computerized application in a fertilizer machine test station allows an adjustment of the fertilizing equipment, reducing the number of required experimental trials. This is due to the fact that initially a search for the optimal parameters through developed application has been carried out and then, a fine adjustment of these parameters by means of experimental tests.

Referències bibliogràfiques

  • Dintwa, E, Van Liedekerke, P, Olieslagers, R, Tijkens, E, Ramon, H. (2004). Model for simulation of particle flow on a centrifugal fertiliser spreader. Biosystems Eng. 87. 407-415
  • Dintwa, E, Tijskens, E, Olieslagers, R, De Beardemaeker, J, Ramon, H. (2004). Calibration of a spinning disc spreader simulation model for accurate site-specific fertiliser application. Biosystems Eng. 88. 49-62
  • Mennel, R. M, Reece, A. R. (1963). The theory of the centrifugal distributor: III: particle trajectories. J. Agric. Eng. Res. 8. 78-84
  • Olieslagers, R, Ramón, H, de Baeremaeker, J. (1996). Calculation of fertilizar distribution patterns from a spinning disc spreader by means of a simulation model. J. Agric. Eng. Res. 137-152
  • Grift, T.E, Hofstee, J. W. (2002). Testing an online spread pattern determination sensor on a broadcast fertilizer spreader. T. of the Asabe. 45. 561-567
  • Swisher, D.W, Borgelt, S. C, Sudduth, K. A. (2002). T. of the Asabe. 45. 881-888
  • Tissot, S, Miserque, O, Mostade, O, Huyghebaert, B, Destain, J. P. (2002). Uniformity of N-fertilizer spreading and risk of ground water contamination. Irrig. and Drainage. 51. 17-24
  • Timoshenko, S, Young, D.H. (1984). Advanced Dynamics. McGraw-Hill. New York^eNY NY.
  • Villette, S, Cointault, F, Pirón, E, Chopinet, B. (2005). Centrifugal spreading: an analytical model for the motion of fertiliser particles on a spinning disc. Biosystems Eng.. 92. 157-164
Fuente de los datos: Dialnet