Ingeniería Energética y Fluidomecánica

2023

1. A convenient method to validate the gas flow of a CFD-CT simulation applied on a packed bed used in gas biofiltration through residence time distributions

   Chemical Engineering Journal, Vol. 451

2. Applying a Software Learning Platform to Implement a Project Based Methodology in Teaching Mechanical Engineering to Undergraduates*

   International Journal of Engineering Education, Vol. 39, Núm. 5, pp. 1049-1058

3. Assessing the performance of a renewable District Heating System to achieve nearly zero-energy status in renovated university campuses: A case study for Spain

   Energy Conversion and Management, Vol. 292

4. Assessment of natural ventilation strategy to decrease the risk of COVID 19 infection at a rural elementary school

   Heliyon, Vol. 9, Núm. 7

5. Catalytic pyrolysis of plastic wastes for liquid oils’ production using ZAP USY zeolite as a catalyst

   International Journal of Environmental Science and Technology, Vol. 20, Núm. 1, pp. 17-30

6. Convective drying of mango stone for use as biomass

   Environmental Research, Vol. 227

7. Estimation of performance parameters of a counter flow cooling tower using biomass packing

   Thermal Science and Engineering Progress, Vol. 44

8. Experimental characterization of an asymmetric valveless pump based on soft robotics technology

   Physics of Fluids, Vol. 35, Núm. 6

9. Experimental performance of a spray tower system for water desalination and indoor thermal comfort

   Process Safety and Environmental Protection, Vol. 180, pp. 122-135

10. Fluid-dynamic impact of commissural alignment in transcatheter aortic valve implantation

    Revista Espanola de Cardiologia, Vol. 76, Núm. 7, pp. 566-568

11. Geometrical and thermal optimization of cylinder-conical blackbody cavities to uniform radiance temperature profiles in the infrared

    Infrared Physics and Technology, Vol. 131

12. Heat capacities of different amine aqueous solutions at pressures up to 25 MPa for CO2 capture

    Journal of Molecular Liquids, Vol. 377

13. Hydrogen or hydrogen-derived methanol for dual-fuel compression-ignition combustion: An engine perspective

    Fuel, Vol. 333

14. Hydrothermal reduction of CO2captured as NaHCO3into formate with metal reductants and catalysts

    Journal of CO2 Utilization, Vol. 68

15. Influence of a soluble surfactant on the transition to tip streaming

    Experimental Thermal and Fluid Science, Vol. 141

16. Influence of packing configuration and flow rate on the performance of a forced draft wet cooling tower

    Journal of Building Engineering, Vol. 72

17. Kinetics of the hydrolysis of sorghum flour with two amilaceouos enzymes

    Afinidad: Revista de química teórica y aplicada, Vol. 80, Núm. 598, pp. 94-98

18. Obtaining the Synthetic Fuels from Waste Plastic and Their Effect on Cavitation Formation in a Common-Rail Diesel Injector

    Sustainability (Switzerland), Vol. 15, Núm. 21

19. Performance Evaluation of a Fuel Cell mCHP System under Different Configurations of Hydrogen Origin and Heat Recovery

    Energies, Vol. 16, Núm. 18

20. Performance characterization of an adaptive-controlled air handling unit to achieve thermal comfort in Dubai climate

    Energy, Vol. 273